11
10
CONTROL PANEL
SENSORPOD
™
Warm Mist
When on, mist is warmed.
Timer Mode
Humidifier will automatically turn off after 2, 4, 8, or 12
hours. To cancel this countdown, simply press button
until no timer setting is displayed.
Filter Change Indicator
Filter indicator glows red when it is time to be replaced.
To reset, simply hold the Filter Reset button for 3
seconds.
If you replace the filter before the indicator turns red,
simply hold the Filter Reset Button for 10 seconds to
notify the humidifier that a new filter has been installed.
Target Humidity
Press the – or + button to set your own target humidity
between 40 - 60%. The humidity level will be displayed
as a percentage on panel (i.e. 45 = 45%).
Dimmer Mode
Display illumination turns off – for use while sleeping –
without sacrificing the effectiveness of the humidifier.
Simply press the button again to bring back all
display features.
Misting Speed Settings
Select misting speed (1/2/3) or AUTO mode. In
AUTO mode, humidifier will only produce mist when
SensorPod measures humidity lower than target
humidity setting. Default AUTO mode setting is 50%
relative humidity.
Power Button
Note: It will take a few minutes to achieve its full temperature.
(See page 14 for replacement instructions. Follow above Reset button
instructions after replacing filter.)
Remote Control
The SensorPod reads the humidity level where it is placed. The battery
operated SensorPod should be positioned in line-of-sight of the humidifier;
up to 33' away.
The SensorPod is also a remote control for your humidifier. Power on and off,
adjust the misting speed, and dim the lights on the display.
The SensorPod communicates with the humidifier using radio frequency
signals and will be pre-paired on the production line and ready for use when
you open the box.
HUMIDITY
Humidifier Controls:
Power on/off
Misting Speed
Dimmer on/off
Battery Chamber
