IP Grade
IP20
3
RMAX-7NX
100868
SDS max
Class II
60 Hz
Hammer Drill SDS MAX
16 AWG x 2C with an insulation temperature of 221 °F
10 A
1100 W
Code
Description
Chuck
Voltage
Frequency
Current
Power
6 kg
7 Joules
Weight
Bit: 35 mm
90 mm
Maximum drilling power in concrete
Drilling diameter in concrete with hollow bits
Rotation: 300 RPM - 760 RPM | Impact: 1950 strokes/min - 4860 strokes/min
Speed
50 minutes work per 20 min rest. Maximum 6 hours daily
Work cycle
Conductors
Insulation
Power Cord Grips used is: Type “Y”.
Tool Build Quality: Reinforced insulation
Thermal insulation on motor winding: Class F
127 V~
Impact energy
Technical Data
Power Requirements
WARNING
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a Authorized Service Center.
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
Tools with double insulation and reinforced insulation are equipped
with a polarized plug (one prong is wider than the other). This plug will only fit in the
right way into a polarized outlet. If the plug cannot be introduced into the outlet, reverse
the plug. If it still doesn’t fit, call a qualified electrician to install for you a polarized
outlet. Do not alter the plug in any way. Both insulation types eliminate the need of both
a grounded third power cord with three prongs or a grounded power connection.
When using an extension cable, verify the gauge is enough for the
power that your product needs. A lower gauge cable will cause voltage drop in the line, resulting in power loss and
overheating. The following table shows the right size to use depending on cable’s length and the ampere capability shown in
the tool’s nameplate. When in doubt use the next higher gauge.
WARNING
WARNING
WARNING
from 0 A and up to 10 A
from 10 A and up to 13 A
from 13 A and up to 15 A
from 15 A and up to 20 A
18 AWG(*)
16 AWG
14 AWG
8 AWG
16 AWG
14 AWG
12 AWG
6 AWG
3 (one grounded)
from 6’ to 49’ | higher than 49’
Ampere
Capacity
Number of
Conductors
Extension gauge
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE
When operating power tools outdoors, use a grounded
extension cable labeled “For Outdoors Use”. These extensions are especially designed
for operating outdoors and reduce the risk of electric shock.
3
ENGLISH
Summary of Contents for EXPERT SDS MAX RMAX-7NX
Page 10: ...10 Notes ENGLISH...
Page 15: ...10 ESPA OL Notas...
