Truper 28147, Manual, Page: 28 / 36

Parts
Fuel and oil
• Verify the oil level: Remove the oil cap with oil level
measuring rod ( A ) and wipe it clean. Set the cap in place
again but do not thread it. Remove the cap once more and
check oil level.
• If oil level is close to or below the lower limit marked in the
measuring rod, fill up with oil up to the oil level marked in
the measuring rod barely touches the upper limit markedSet
the cap back and thread it.
• The motor can seriously get damaged
with no oil. Always check oil level before operating the
mixer. The mixer shall always sit on level ground to correctly
measure the oil level.
Oil supply
• Set the mixer onto flat and leveled surface.
• Clean and dry the area around the fuel cap.
• Remove the fuel cap ( B ).
• Using a funnel fill up the fuel tank slowly up to the
maximum level mark.
• Clean any fuel spilling.
• Close the cap turning it until hearing a click.
• Clean any fuel spills before starting the mixer.
Fuel supply
CAUTION
10
ENGLISH
Fuel
tank
Muffler
Spark plug
cable
Fuel tank
cap
Pulley
Switch
Oil cap with
oil level
measuring rod
A
B
Motor
axis
Air filter
cover
Starter
Choke
lever
Clean
unleaded
gasoline
Automotive
Oil SAE 10W-30