Truper 17269, Manual

Page: 24 / 32

Start up and operation control
• Intermittent Operation:
Connect the switch to the power outlet.
Press the switch ( D ) to start the tool.
To interrupt, just release the switch.
• Continuous Operation:
Connect the switch to the power outlet.
Press the switch ( D ) and block it pushing the continuous use
button (
E
).
To interrupt, press and release the switch.
Speed adjustment
• The tool speed can be changed with the speed selector ( F ).
• For a lower speed turn the selector counterclockwise.
• For a higher speed turn the selector clockwise.
Do not turn the selector while the tool is
being operated.
Continuous use in a low speed could
damage the saw.
8
Start up
F
D
Choosing the right speed
The speed used will depend on the material to be cut.
• Use high speed to cut woods and similar materials such
as hardwood.
• Use medium speed to cut non- ferrous metals, plastic
and fiberglass.
• Use the low speed to cut ferrous metals like pipes or
steel angles.
• If the blade speed is too low for the job to do, the blade
could vibrate when starting to cut and could cause
kickback. When starting to cut use a light high speed. Is
always a good idea practicing cuts on scrap material until
having the right sensibility to cut and good handling of the
saw.
The thickness of the material and type of
blade will affect the speed selection. As a rule of thumb
use HIGHER SPEEDS and blades with the less teeth per
inch for softer metals. Use LOWER SPEEDS and blades
with more teeth per inch for thicker or dense materials.
E
CAUTION
WARNING
CAUTION
ENGLISH