Truper 17247, Manual

Page: 15 / 24

3
COMP-AERO
17247
60 Hz
Airbrush Diaphragm Compressor
Code
Description
Voltage
Frequency
1/5 Hp
Power
6 gal/min Output ¼-18-NPT
58 PSI
Maximum Pressure
Continuous Air Flow
5 minutes’ work per 20 minutes’ rest.
Maximum 3 hours daily.
Work Cycle
5,2 ft IP20
Cable length IP Grade
Technical Data
Power cord grips used in this product: Type “Y”.
Tool Build: Class I
Thermal Insulation of Motor Winding: Class F
110 V
ENGLISH
Power Requirements
A
B
CAUTION
CAUTION
To prevent electric shock, the tool shall be grounded while
in use. • Connect the plug into a correctly grounded outlet as shown in
example A . Not all the outlets are properly grounded. If in doubt, verify with a
qualified electrician. • If the outlet where you will connect the tool has two
poles (2 orifices). UNDER ANY CIRCUMSTANCE, DO NOT REMOVE OR
ALTER THE PLUG’S GROUND CONNECTOR. Use a temporary adaptor as
shown in example B and always connect the ground conductor lug as shown.
When using an extension cable, verify the gauge is enough
for the power that the tool needs. A lower gauge cable will cause voltage drop
in the line, resulting in power loss and the motor will overheat. The following table shows the right size to use depending on cable’s
length and the ampere capability shown in the tool’s nameplate. When in doubt use the next higher gauge.
WARNING
WARNING
When using power tools outdoors use a grounded extension cable labeled “Outdoors
Use”. These extension cables are specially manufactured for outdoors use and reduce the risk of electric shock.
From 0 and up to 10 A
From 10 and up to 13 A
From 13 and up to 15 A
From 15 and up to 20 A
18 AWG
16 AWG
14 AWG
8 AWG
16 AWG
14 AWG
12 AWG
6 AWG
3 (one grounded)
From 6 ft to 49 ft | Higher than 49 ft
Ampere
Capacity
Number of
Conductors
Extension Gauge
WARNING
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a Authorized Service Center.
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.