N
M
L
K
• Connect the machine to a power source with the
specified voltage and frequency.
• To start the disc’s rotation, press the switch ON ( )
button.
• To stop the disc, press the switch OFF ( ) button.
• Allow the disc to reach the maximum speed before
starting to cut.
• Set the straight cut guide (
K
) into the desired cutting
width. As reference, use the scales shown on top of the
table.
• Adjust the cutting guide partially in place turning the
lock (
L
) in a clockwise direction. To block the guide in
place, push the lever all the way down.
• Set the tile against the cutting guide and push it towards
the moving disc. Hold the tile firmly and do not separate it
from the cutting guide.
• Set the miter cut guide (
M
) on top of the straight cut
guide.
• Adjust the desired angle (from 0° to ± 45°) and tighten
the knob to block the angle.
• Set the tile against the miter cut guide and push it
towards the moving disc. Hold the tile firmly and do not
separate it from the cutting guide.
• Loosen the blocking knobs (
N
) in both sides of the
table.
• Adjust the desired angle (from 0° to 45°) and tighten
the knobs to block the table.
• Set the tile against the cutting guide and push towards
the moving disc. Hold the tile firmly and do not separate it
from the cutting guide.
8
Start Up
Switching ON and Operation
Straight Cut
Miter Cut
Bevel Cut
ON
OFF
ENGLISH
