8
Start Up
Operation
• Turn on the compressor and fill it.
• Regulate the air compressor output pressure to 75 PSI and
110 PSI
The tool operates with this pressure
range. If operating with a higher pressure ranges the useful
life of the tool will be decreased.
• Load the cartridge as indicated on page 7.
• Use a piece of scrap wood to verify the
tool works correctly.
• Not putting your finger on the trigger position the tool and
press the contact lock against the surface to be used (
A
).
• Without lifting the tool press the trigger to shoot (
B
).
• Immediately release the trigger and lift the tool (
C
).
• Position the tool back for subsequent shots.
• In case the nails are not penetrating deep enough, slightly
lift the air pressure until reaching the right penetration force.
Remember not to exceed 110 PSI
Blocked nail in the shooting orifice
• Disconnect the tool from the air supply.
• Open the nozzle and pull the nail using pliers until
removed.
Blocked nail in the cartridge
• Disconnect the tool from the air supply.
• Open the cartridge.
• Remove the blocked nail with pliers.
• Close the cartridge.
CAUTION
WARNING
WARNING
A
B
C
ENGLISH
