3
13106
50 V
Fan
IP21S
60 Hz
Stick welder
Code
Description
Voltage
Frequency
Current
Power
Rated voltage with no load
Technical data
Power cord grips: Type “Y”.
Tool Build quality: Basic Insulation
The class of thermal insulation of the windings: Class H
Power requirements
90 A - 210 A
90 A - 130 A
Current adjust range
Type of cooling
Insulation
Class I
IP Grade
SOT-250AL
• The connection to the power source shall be carried out by a
professional electrician and should follow the electric diagram shown to the right.
• Double-check that the input connection
voltage shown in the welding machine nameplate matches with
the voltage in the power source (220 V or 110 V). The connection
screws shall be tightly fastened.
• The cord gauge in the power source shall
meet the following requisites:
CAUTION
CAUTION
CAUTION
• The welding machine shall be perfectly grounded before
operating and ground shall not be disconnected before finishing the welding job;
otherwise the operator may receive an electric shock and get severely injured.
• There shall be a parallel connection when the tool is using the same ground
together with other tools. Never connect a series of devices.
• The gauge in the ground conducting cable cannot have a lower
gauge then the power cable.
* The fuse fusion current is double of its rated current.
CAUTION
WARNING
Ground
connection bolt
Switch
Power cord
100 A
0.009 in
2
If extensions are required between the welding machine and the
work piece, the welding cord gauge shall be increased in order to
keep the welding machine energy output with a potential drop not
higher than 4 V
ENGLISH
WARNING
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a Authorized Service Center.
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
110 V
220 V
68 A
54 A
7.5 kVA
12 kVA
Input
Output
1 minute work per 9 minutes rest.
Output values specified are with a 68 ºF Temperatures higher than the work cycle may be reduced.
Duty cycle
F
Input diagram in the connections board
220 V˜
110 V˜
S
R
S
Output
Power source
110 V / 220 V
˜
˜
