7
Assembly
A
F
L
H
G
M
J
B
E
C
I
K
• Fix the wheels set passing the axis (
A
) through each
wheel (
B
) and its respective mounting orifice (
C
) into the
chassis. Secure with the pin (
D
) and the washer (
E
).
• Install the high-pressure holders and the metal rod into
the chassis as shown in the figure.
• Assemble the metal rod (
F
) to the high-pressure gun (
G
)
threading in a clockwise direction, the gun to the
high-pressure hose (
H
) and the hose to the pump (
I
).
These as fast connections.
• Close the garden hose faucet (
J
) fully. Connect the
garden hose to the garden hose inlet (
K
). To connect and
prevent kinking the garden hose turn the connection knob.
• Use care no to thread the connections
unevenly to prevent pressure loss.
• Once the connection is set and WITHOUT touching any
nozzle (
L
) in the metal rod open all the way the garden
hose faucet. Tighten the high-pressure trigger until a
constant water flow is out from the metal rod. The purpose
of this movement is to purge the system from air bubbles.
• If using detergent into the pressure washer, connect the
detergent hose to the connection
M
.
CAUTION
ENGLISH
Untangle and straighten all the hoses in
full to prevent twists cutting the water flow
Double check there are
no leakage in the hose
D
