8
E
F
A
B
x 6
C
G
ENGLISH
Fuel supply
Start up
Starting
Turning OFF
• Follow the safety standards for handling fuel (Page 5).
• Allow the motor to completely cool down before filling up.
• Set the string trimmer lying it down onto a flat surface as
shown in the figure.
• Wipe around the fuel tank cap to prevent contamination.
• Slowly loosen the fuel cap.
• Use care to avoid spillage. Pour the fuel mix into the fuel
tank. Follow fuel specifications (Page 3).
• Before setting back the fuel cap check and clean the
joints.
• Immediately set the fuel tank cap back and tighten by
hand.
• Wipe clean any fuel spills.
In a new motor and after running it for
the first time it is normal that smoke emissions are
present.
CAUTION
CAUTION
• Set the tool onto level ground using care the
cutter head is not making contact with any
obstacles.
• Set the switch in the ON position (
A
).
• When the motor cools down move the choke
lever (
B
) upwards. Press and release the primer
bulb (
C
) 6 times.
• If the motor is hot move the choke lever
downwards. Do not use the primer bulb.
• Pull the starter/handle (
D
) quickly to start the
Starting with
a Cold Motor
Only for cold
starting
Starting with
a Hot Motor
motor. Once the motor is running do not release
the starter/handle, carefully set it back to its initial
position to prevent damaging it.
• Once the motor is running move the choke
lever downwards.
• Let the motor run idle a couple of seconds.
• Set the harness onto your shoulder. Hold the
string trimmer by both handles using both hands.
Lift it to start cutting.
• Press the lock (
E
) and the throttle trigger (
F
) to
start the cutting device.
• Release the lock (
E
) and the accelerator trigger (
F
).
• Set the switch into the off position (
G
).
D
Summary of Contents for 12497
Page 12: ...12 Notas ESPA OL...
Page 26: ...12 ENGLISH Notes...
