• Check that the battery has an adequate charge level,
otherwise charge it.
• Let the machine rest for a few minutes and try again.
• Turn the switch to on, in case the machine does not
start take it to a Authorized Service
Center.
• Remove the battery and make sure it is inserted
correctly by inserting it into the vacuum cleaner's
receptacle until it clicks.
• Install or replace the filter.
• Assemble the filter according to the assembly section
on page 7.
• Take the machine to a Authorized
Service Center.
• Remove the filter and clean it as described in the filter
cleaning section on page 7. Do not install the filter until it
is completely dry.
• Replace the filter with a new one.
• Check the accessories, if any object obstructs the air
flow, remove it.
• Transport the machine horizontally after cleaning to
avoid dust leakage.
• Take the machine to a Authorized
Service Center.
• Immediately clean liquid from skin and/or clothing with
soap and water.
• Replace battery.
• Insert the battery correctly into the charger.
• Check that the charger plug is properly connected to
the socket.
• Replace the battery with a new one.
Vacuum cleaner does
not work
Dust comes out of the
engine vents
Reduced machine
efficiency (motor
vibration, low motor
suction)
The dust is scapes
from the dust
container
Battery is leaking
Battery does not
charge and charge
level indicator light
does not turn on
• Low battery.
• The battery has overheated.
• Switch is in the off position.
• Battery not inserted correctly.
• Filter is not installed or is damaged.
• The filter was not installed properly.
• The lip seal of the dust compartment lid
was damaged.
• The filter is dirty or wet.
• There is a blockage in any of the nozzles,
adapter or extension.
• It is normal for some dust to escape
through the dust trap depending on how
the machine is transported.
• Damaged or punctured dust trap.
• Tiny drips may occur in extreme
temperatures or after heavy use. This is
normal.
• Damaged battery.
• Charger connection incorrectly
installed on the battery.
• Charger incorrectly connected to the
socket.
• Damaged battery.
Problem
Cause
Solution
If problems persist despite performing the recommended corrective actions,
contact a Authorized Service Center.
ENGLISH
10
Troubleshooting