Truper 101402, Manual

Page: 8 / 24

20V
8
Start Up
Turn On and operation control
• Press the switch to start operation. Release the switch to
stop the operation.
• The switch allows selecting the adequate speed for each
job. The more you push the switch the fastest the hammer
drill will run.
The LED light is
activated when the
switch is pressed.
When the switch is
released, the light will
stay on for a
maximum of 6
seconds.
ENGLISH
Screwing - Unscrewing
Consider the following points as the tightening torque can
be affected by each of them:
• Voltage: Low voltage from a nearly completely discharged
battery or battery will reduce the tightening torque.
• Accessory size: Failure to use the correct accessory size
will cause a reduction in tightening torque. - Bolt size:
Larger diameter bolts generally require greater fastening
torque. Locking torque will also vary according to length,
grade and torque coefficient.
• Bolt: Make sure all threads are free of rust and other
debris to allow for proper tightening torque.
• Material: The type of material and surface finish of the
material will affect the tightening torque.
• Tightening time: Longer tightening time increases the
tightening torque. Longer than recommended tightening
time may put too much stress on the fasteners or cause
them to roll or become damaged.
Speed selection
Your tool is equipped with a speed selector that allows you to
select a speed and torque according to the application:
• Press the switch until the speed selector LED light turns on
• Press the speed selector button.
• The green LED light will indicate the selected level
• Press the button until the desired level is reached.
Screwing
Level 3
Level 2
Level 1
Speed (RPM) / Max. Torque (lb-ft)
0 - 2 700 RPM / 221 Ib-ft - 300 Nm
0 - 2 100 RPM / 184 Ib-ft - 250 Nm
0 - 1 800 RPM / 162 Ib-ft - 220 Nm
Level 1
Level 3
Unscrewing
Level 2
LED light
stays off
Level 1
LED light
stays on
Speed (RPM) / Máx. Torque (lb-ft)
0 - 2 700 (RPM) / 184 Ib-ft - 250 Nm
140 (RPM)
Screwdriver mode indicator