Truper 101402, Manual

Page: 6 / 24

20V
Parts
Handle
Rotation and block
direction button
LED
light
Battery
connection
teeth
Switch
Battery
release
button
Battery
Belt clip
Battery
charger
Bit
holder
6
ENGLISH
1
2
Start Up
Battery charge
1
. Plug in the charger in a 127 V~power outlet (The green
light on the charge initiator will turn on).
2
. Insert the battery into the charger sliding it as shown in
the figure. The green light will go out and the red light
should be on indicating the charge has initiated.
• When the battery is completely charged, the green light
will be on and the red light will be off.
• Disconnect the charger from the power once the charge
is completed.
• If the red light is blinking it signals a defective battery.
Replace with a new one.
• In case the green light is blinking it signal the
temperature in the battery is lower to 32 °F or higher than
113 °F. Wait until the battery temperature is in the
adequate level to be able to charge it.
In model MAX-20DS,
battery and charger are sold
separately.
NOTE
Battery
level indicator
Bit holder
collar
Charge
indicator