Energy chain
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
49
12.6
Energy chain
Disassembly
1. Prepare the operating table (see chapter 7 on page 29).
2. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
3. Remove the pad plate of the seat section (see chapter 12.2 on
page 40). Important: keep the back section pad plate
attached so that the bar adjustment is retained.
4. Remove the cover from the center box (see chapter 12.3 on
5. Be sure to note the cable routing.
Remove protective conductor_24 [1] from the center box [4]
and from the inside of the bar [4] (each with 1 screw with 2
washers).
6. Disconnect the leads of cable W166/W167 [2] from the
plug of the CAN distributor circuit board [3] (center box).
7. Be sure to note the cable routing.
Unfasten ground wire_24 [1] and cables W166/W167 [2]
from the center box [5] to the end of the energy chain on the
inside of the bar [4].
8. Remove the energy chain [6] (chain connection) from the
center box [5] and the inside of the bar [4] (2 screws each).
9. Lay the energy chain [6] straight and carefully pull all cables
out of the energy chain.
Assembly
1. Draw a wire pull through the energy chain.
2. Fasten the cable W166/W167 and the ground wire_24 to
the wire pull.
3. Straighten the energy chain and carefully pull the wire pull with
the cables through the energy chain without twisting.
4. Pull the cables in the energy chain equally taut. Pull the excess
end of the cable out of the energy chain according to the
cable routing.
5. Remove the cables from the pull wire.
6. Place the energy chain back in its original mounting position!
Mount the energy chain (chain connection) on the center box
and the inside of the bar (2 screws each).
7. Attach ground wire_24 to the center box and the inside of the
bar (each with 1 screw with 2 washers).
8. Lay cable W166/W167 in the center box.
Summary of Contents for TruSystem 7000
