Trumpf TruSystem 7000, Service Manual

Page: 196 / 306

Cable W193
196
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
20.10 Cable W193
Cable W193 is not available on all operating table versions.
Disassembly 1. Prepare the operating table (see chapter 7 on page 29).
2. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
3. Remove the pad plate of the seat section (see chapter 12.2 on
page 40). Important: keep the back section pad plate
attached so that the bar adjustment is retained.
4. Remove the cover from the center box (see chapter 12.3 on
page 41).
5. Pull the cover from the remote control socket.
6. Disconnect the shielded connection from the remote control
socket [1] and remove the counter nut [2].
7. Unplug cable W193 [3] from the Endolight interface circuit
board [4].
8. Disconnect the leads of cable W193 from the plug, so that the
cable can be pulled through the opening in the center box
9. Note the assembled position of the socket.
From the outside, pull socket [1] with cable W193 out of the
center box and the counter nut.
10. Remove the counter nut from the center box.
Assembly 1. Restore the socket to its original assembled position.
From the outside, carefully pull the cable through the center
box and then through the counter nut.
2. Tighten the counter nut.
3. Connect the shielded connection to the connection contact of
the socket.
4. Restore the original cable routing.
Route cable W193 in the center box.