Cable W166 and W167
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
185
20.4
Cable W166 and W167
Disassembly
1. Prepare the operating table (see chapter 7 on page 29).
2. Switch off the operating table and disconnect the internal
power supply (see chapter 10 on page 33).
3. Remove the pad plate of the seat section (see chapter 12.2 on
page 40). Important: keep the back section pad plate
attached so that the bar adjustment is retained.
4. Remove the cover from the center box (see chapter 12.3 on
5. Be sure to note the cable routing.
Unfasten cable W166/W167 [1] from the CAN distributor
circuit board [2] (center box) up to the end of the energy
chain [4] on the inside of the bar.
6. Disconnect the leads of cable W166/W167 [1] from the
plug of the CAN distributor circuit board [2] (center box).
7. Be sure to note the cable routing.
Remove ground wire_24 [5] from the center box [7] (1 screw
with 2 washers).
8. Remove the energy chain (chain connection [4]) from the
center box (2 screws).
9. Lay the energy chain straight and carefully pull the cables out
of the energy chain.
10. Remove the energy chain (chain connection [8]) from the
inside of the bar (2 screws)) to gain access to the screws on
the bar cap [9].
11. Be sure to note the cable routing.
Open the cap [9] on the bar (4 screws) and gently tilt it so the
underside of the circuit board is accessible. Jiggle the energy
chain back and forth to access the screws on the bar cap.
12. Disconnect the leads of cable W166/W167 [1] from the
plug of the CAN distributor circuit board [10] (bar cap) and
remove the shielded connection (1 screw with 2 washers).
Assembly
1. Draw a wire pull through the energy chain.
2. Attach the leads of cable W166/W167 to the plug on the
CAN distributor circuit board (bar cap) (see circuit diagram on
page 295) and attach the shielded connection (1 screw with
2 washers).
3. Restore the original cable routing.
Pull cable W166/W167 through the recess on the bar cap
and close the cap (4 screws). Make sure that no cables are
pinched.
Summary of Contents for TruSystem 7000
