20
Maintenance
E543EN_03.DOC
Maintenance point
Procedure and interval
Recommended lubricants
Order no.
Lubricants
Cutting tool guide
Every 50 cutting metres and with
tool changes
Lubricating grease "G1"
0139440
Gearbox and gear head
Have them relubricated or the
lubricating grease replaced by a
qualified specialist every 300
operating hours.
"G1" lubricating grease
0139440
Wearing plate
Turn as needed
-
-
Wearing plate
Replace as necessary
-
-
Pressure die
Clean as needed
-
-
Ventilation slots
Clean as needed
-
-
Regrind cutting tool
Regrind it as required
-
-
Replace cutting tool
Replace as necessary
-
-
Maintenance points and maintenance intervals
5.1 Regrind
cutting
tool
The cutting tool for mild steel (Order No. 088503) and for high-
tensile sheets (Order No. 089335 has two cutting edges. It does
not need to be reground until both edges are blunt.
Regrind the cutting tool flat (90°) on the grinding face when
both edges are blunt.
Note
The minimum length must be observed. Shorter cutting tools are
not usable.
The cutting tools for aluminium and the heavy-duty cutting tools are
ground at an angle on the grinding face. Please observe the respec-
tive regrinding diagram. (see Fig. 9666, p. 13)
Checking cutting tool guide wear
Replace the cutting tool guide (6) if the play between the cut-
ting tool guide and the cutting tool has increased to more than
0.3 mm.
Table 6
