Trumpf BendMaster 150, Operator'S Manual

Page: 32 / 258

The key must be removed and kept safely.
The key switch is located on the mounting device for the porta-
ble manual control unit and has the following positions
(see "Fig.
46231", pg. 4
‐
17) :
Switch setting Description
(zero position)
None of the axes can be moved.
(TruBend manual)
Press brake can be operated without BendMaster. The BendMaster is in home
position.
(Manual mode)
Only the axes of the BendMaster can be moved at reduced speed.
The ENABLE KEY on the portable manual control unit must be pressed the
whole time.
(Automatic mode)
All axes move at the programmed speed.
The program is started using the START button on the portable manual control
unit.
The operator must be outside the safety cabin.
Tab. 1-5
The traveling speed of the axes is reduced automatically in man-
ual mode. The maximum traveling speed at the center of the
gripper is 250 mm/s.
4.2 Danger signs on the machine
Danger signs indicate dangers when operating the machine.
1
‐
16
Measures to be taken by the manufacturer 2015-06-01
B579EN
Reduced speed in manual
mode