Truma Mover S, Installation & Operation Instructions

Page: 8 / 16

8
Special accessory installation
1. Set of screws
for height compensation with
spacer plates, max. 45 mm
eight DIN 933 screws
M10 x 95 8.8, galvanized,
part no. 60010-70000.
2. Spacer plate kit
(two 15 mm spacer plates)
for height compensation
max. 45 mm (3 Plates) at each
side (e.g. installed behind axle)
part no. 60010-66000.
3. Low chassis kit
For height compensation for
caravan / trailer with frame height
of
less than 140 mm,
part no. 60010-64900.
In Germany, this installation
kit must be accepted by a
vehicle expert.
4. AL-KO Vario III / AV
Installation kit
For caravans with
AL-KO Vario III / AV Chassis
(frame thickness less than
2,8 mm)
mandatory,
part no. 60010-21500.
5. Mover mounting set
for Eriba-Touring
part no. 60030-09000.
Installation is not possible in
some cases because of
attachments to the underbody.
Contact your dealer if necessary.
60 - 100 mm
Detailed installation instructions are provided with the
relevant mounting set.
The Mover S is not approved for installation on
caravans / trailers with any other chassis!
Any drilling (exception: when using flat frame kit) or welding
to the chassis is not allowed. Under no circumstances remove
any suspension components from the chassis.
Choice of location
The Mover should preferably be installed in front of the axle,
but can also be installed behind the axle under special circum-
stances (e.g. lack of space). Only the bolts that are provided
must be used to secure the Mover (or the add-on parts
provided as special accessories).
Installation of the drive units
The frame of the vehicle must be kept free of rust and heavy
soiling and without any damages to the suspension components.
The wheels and tyres that are fitted to the caravan must be of
the same size and model and inflated as per the manufacturer’s
instructions.
Remove all components from packing and place on the floor.
In order to maintain the validity of the General Operating
Permit (ABE) the provided factory plates (f) must be
attached on the left and right sides of the cross strut between
the drive unit retaining plates.
f
Loosely attach the drive units to the lateral bar. The bolts (lock
nuts) must be no more than finger-tight.
Nut M8 (4x) M8 x 30 (4x)
Place the mounting set (b) on the vehicle frame and secure
using the two bolts (c), tight enough so that it can just about
be moved on the frame.
c
b
M8 x 60 (4 x)
Self-locking nut M8 (4 x)
Washer 8
(8 x)
Bolt drive units with lateral bar to mounting set using U-bracket
(d), tight enough so that it can just about be moved.