Installation of water supply
Installation Drawing (Integrated Ice Machine)
4
1. Ice machine must use room-temperature drinkable water.
2. Water pressure must be controlled between 0.15 MPa and 0.3 MPa.
3. Inlet hose with 3/4” internal thread (20mm) and 1/2” internal thread (15mm) joints
at both ends,which has a stone guire seal washer so that there is no need to wrap
raw tape.
4. Filter is equipped with filter element, use a wrench to unscrew the filter element
before using, take out the filter element, tear off the packaging film of the filter
element, install back as it is and tighten it. A new filter element should be replaced
every six months.
5.The direction of inlet and outlet is marked on the filter cover. Please pay attention
to the installation.
6.Connect the 3/4’ joint to the machine inlet (white 3/4’ male thread)1/2 joint to the
water supply pipe.
7.For water cooling ice machine, the machine added two 3/4’ pipe joint at the place
of in and out, which color is black to distinguish the ice making inlet.
8.The ice machine drains water by gravity, so it is necessary to ensure adequate
slope and drop.
Drain Pipeline
（
Black
）
Power
Filter
Ice making water inlet
（
white
）
Before using filter,must take out
the filter element, tear off the
packaging film of the filter
element, install it and tighten it.
