6
-
WARNING:
Connect to the water supply. The machines are not suitable for connection to
portable water mains. Connect the machine to the water supply. (It can be a water container).
Make sure the inlet water pressure keeps between 0.01MPa and 0.4MPa.The inlet pipe should
at least 5 M long. Do not use the pipe if the pipe is damaged. If you want connect this machine
to portable water mains, you must install a backflow preventer in the water pipe to prevent dirty
water flow back to the drinking water system. The backflow preventer shall comply with EN
60335-2-79 ANNEX AA.
OPERATING INSTRUCTIONS
!
This unit is to be connected to a cold water source
ONLY
.
!
The motor of this pressure washer will NOT run. It will only operate when the trigger is
squeezed.
- Connect the outlet hose to the washer and connect the spray gun to the outlet hose.
- Connect nozzle and nozzle extension.
- Check gauze filter is clear of any blockage.
- Connect the water supply hose.
- Check that the hose has no kinks in it.
- Turn on water and check for leaks.
- Depress trigger to allow air to be expelled though the pump and hoses, lock trigger.
- Plug in machine and turn on switch.
- Unlock trigger and use the pressure washer.
Shut down
1.
Turn off the motor(push switch to the off position).
2.
Unplug the unit from the power source.
3.
Turn off the water supply.
4.
Press the trigger of the gun to depressurize the system.
5.
Disconnect the garden hose from the pressure washer.
6.
Wipe all surfaces of the unit with a damp clean cloth.
7.
Engage the gun safety lock.
CAUTION:
ALWAYS turn off the unit’s motor BEFORE turning off the unit’s water supply.
Serious damage could occur to the motor if the unit is run without water.
CAUTION:
NEVER disconnect the high-pressure discharge hose from the machine while the
system is still pressurized. To depressurize the unit, turn off the motor, turn off the water supply
and squeeze the trigger 2-3 times.
SELECTING THE RIGHT NOZZLE FOR THE JOB
NOTE:
To prevent damage to your surface and to select an appropriate nozzle size for your
application, always start with lowest pressure nozzle size and continue changing to the higher
nozzle size until the best work result is achieved. The Pressure Washer comes furnished with
four spray nozzles. Each nozzle is color coded and delivers a specific spray pattern and
Summary of Contents for 1653000W
Page 10: ...10 Motor Capacity 2500 W Power Supply Voltage 230V 50Hz...
Page 72: ......
