Truefitness.com / 800.426.6570 / 636.272.7100
13
CHAPTER 2: ASSEMBLY INSTRUCTIONS
ASSEMBLY STEPS (continued):
Step 3 Seat Handlebar Cable Connections:
Step 4 Seat Handlebar Assembly:
•
Install the seat handlebar bracket into the seat
carriage; the handlebar top bracket should sit
on seat carriage (as shown in diagram, left)
•
For each counter-bore hex screw (C4,
quantity 4), start each screw through the seat
carriage and handlebar bracket, using the
provided 5mm hex wrench
•
For each hex screw (X4, quantity 2), install
through quantity 1 split washer (S4), followed
by quantity 1 flat washer (F4)
•
Start each hex screw through the handlebar
bracket and seat carriage, using the provided
5mm and 6mm hex wrench
•
Tightening 4 screws (C4) with 5mm hex
wrench and the other 2 screws (X4) with 6mm
hex wrench provided
•
Prior to connection, verify the handlebar is in the
correct orientation; graphics on the contact heart rate
thumb switches should be facing up
•
Connect the handlebar cables, as shown by the
connection lines in the provided diagrams (above, left)
