
S
TEP
5: I
NSTALL
THE
L
OW
P
ULLEY
C
ABLE
Route the cable
out this hole.
Use this pre-installed wire tie to pull the
cable through the Low Pulley by wrapping it
around the threads of the bolt.
Use this pre-installed wire tie to pull
the cable through the Low Pulley.
1. Route the cable out the bottom of
the upright. Attach the pre-installed
wire tie to the cable bolt by wrapping
it around the bolt threads, and pull
the cable through the Low Pulley
tube.
2. Assemble the Low Pulley weldment
as shown.
3. After aligning all the edges, tighten
the hardware.
4. Assemble the cable end piece as
shown on the following page.
Assemble the cable end
piece as shown on the
following page.
You will need
to remove
this pulley to
route the
cable.
Strength
Strength
MP
MP 33.0
.0,, 33.5
.5, & 4.0
, & 4.0
TTrrue Fi
ue Fittnnes
ess T
s Teecchn
hnoolog
logy • O
y • O’’FFaalllo
lon, M
n, MO • P
O • Phhoonne: 800-426-6570/636-272-7100 • T
e: 800-426-6570/636-272-7100 • Trr
uefi
uefi
ttnnes
ess.co
s.com
m
Page # 26 of 64
P05-1000