Copyright 2018 TruckCraft Corporation Rev. 3/2018
TruckCraft Corporation
5751 Molly Pitcher Hwy
South
Chambersburg, `PA 17202
TC
-
503 Dump Bodies
Tel. (800) 755
-
3867
Fax. (717) 375
-
2975
E
-
Mail:
Web: www.truckcraft.com
6.
With the safety prop supporting the dump body and the truck level, check
the depth of the oil in the hydraulic reservoir. The depth of the fluid in the
tank at this position should be
3”.
Use automatic transmission fluid only to
fill the reservoir to this level.
7.
Apply grease at twelve grease zerks:
See
HOIST & SUBFRAME GREASE FITTING CHART (I5
-
080854)
for
location of the fittings.
8.
Install the light, mount bracket and decal shown in figure 7 on the dash in-
side the cab of the truck. Using
the fuse holder, wire the light to
the dump switch mounted on
the front of the sub
-
frame
across from the hydraulic reser-
voir. Use the schematic shown
in figure 8 to connect the wir-
ing.
Note:
Wire not supplied by
TruckCraft.
9.
Place the two decals A4
-
04684
and A4
-
04685 inside the cab
on the dash in an easy to read location.
10.
Connect the marker light wiring harness to the truck wiring.
11.
Push the remote control up but-
ton. Raise the hoist high
enough to drop the safety prop
back into its storage position.
Cycle the hoist through the
complete stroke of the tele-
scope cylinder a couple times to
make sure everything works
properly.
Warning: Never use the safety prop to support a loaded deck. Never position
yourself under a loaded deck.
F
use
Pilot
Hot Wire
From Truck
Electrical
System
Dash
Dump
Switch
Ground
Figure 8: Dump Bed Raised
Lamp Wiring Diagram
Lamp
Connecting wiring
by installer.
7
