4mm
4
Wood dowel (4x30mm)
Wood dowel (4x30mm)
Rib template (2mm ply)
6.2mm
Blind Nut
Screw(6x50mm)
2
2
Blind Nut (6mm)
Screw(6x50mm)
Reinforcement Plate
Reinforcement Plate
1
Assemble the wings to the fuselage with screw
and blind nut as below.
2
1
Steel wire (0.5x3000mm)
U-style wire (170x3mm)
B'
A
A'
B
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
A = A '
B = B '
2
Steel wire (0.5x3000mm)
1
U-style wire (170x25mm)
Pin hinge(24x24mm)
6
4
Matal douel (4x30mm)
1
Rib template (2mm ply)
1
Stab joiner (12x270mm)
4mm
1
Rib template (2mm ply)
Rib template (2mm ply)
Assembly of the stabilizer.
Set the U-style wire through the enlarge hole as below.
A ccording to thr rib template drill holes to the tail of
fuselage as below.
Drill two holes at the stabilizer root base via rib template
and epexy the wood dowel in them.
28
29
30
32
6
31
Accessory list for the coming installation steps.
2
Steel wire (0.5x3000mm)
2
2
2
Clevis
Washer(3x15mm)
Lock Nut (3mm )
1
Screw (3x80mm)
2
Copper joiner
Washer(3x15mm)
Screw (3x80mm)
Lock Nut (3mm )
Clevis
Aluminum tube
Steel wire
60mm
3mm
Drill a hole to appropriate position in the
rudder as illustration.
The sketch map after the rudder shaft assemble finished.
The sketch map of the linkage for the rudder
and the tail wheel.
The sketch map of the linkages for the rudder
and elevator in the fuselage.
70mm
110mm
2
Plastical tube(3x30mm)
2.5mm
Drill holes to the relevant position in the tailing edge
and epoxy the rudder to them.
Drill a small hole to appropriate possition in the
fuselage for installing the plastical tube.
60mm
3mm
4
4
Clevis
Copper joiner
4
4
Screw (2x10mm)
Nut (2mm )
4
Washer(2x5mm)
Steel wire
Copper joiner
Lock Nut (2mm )
Screw (2x10mm)
Ball joint
Washer(2x5mm)
Install the servo.
56
55
59
60
11
58
Accessory list for the coming installation steps.
57
