Trim the cowling for engine and muffler.
Assemble the receiver and the battery to appropriate
positon in the fuselage.
The servos installation finished sketch map.
Throttle servo
Rudder servo
Elevator servo
switch servo
16
Screw (2x10mm)
Washer (2x5mm)
34
20
Nut (2mm )
20
TP Screw (2.3x12mm)
4
2
Pin hinge (36x20x1mm)
14
Ply(15x15x3mm)
14
TP Screw (2.3x8mm)
1
2
2
Canopy
Wooden Block(100x20x3mm)
hatch hinges(3mm)
B'
A
A'
B
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
A = A '
B = B '
Assembly of the stabilizer.
Metal wire (0.8mm)
Nose wheel servo
Install the servo of switch.
12
64
60
Accessory list for the coming installation steps.
62
61
63
15mm
120mm
6mm
According to the rib template drill holes to another
main wing.
2
Wood dowel (6x30mm)
Rib template (2mm ply)
6mm
1
Rib template (2mm ply)
6mm
Main wing joiner 1
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
6mm
120mm
2
Wood dowel (6x50mm)
Rib template (2mm ply)
According to the rib template drill holes in one wing and
epoxy wood dowel in them.
Epoxy the main wing hardly together with wing joiner.
Drill holes to appropriate position in the front of mid
wing and epoxy wood dowel in them.
20mm
120mm
60mm
R10mm
R10mm
Air tube
Servo wire
Drill holes to relevant position in the fuselage.
Trim holes in the appropriate position in the wings
and drag the servo wire and the air tube out.
23
22
26
5
27
24
25
