1mm
Tailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Keep some space about 1mm width between the rudder
and tail edge.
Epoxy the pivot & round hinges to the rudder,drill holes to appropriate
position in the rudder and assemble the tail landing gear to it as shown.
According to the illustration below bend the tail landing
gear wire and cut off the surplus part.
Epoxy the rudder to the vertical fin..
Assemble the tail landing gear to tail fuselage as below.
Epoxy the control horns to the slots in the rudder.
Rudder
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Make sure hinges are
mounted in the same line.
3mm
35mm
35mm
25mm
TP Screw (2.3x12mm)
27
26
6
29
28
31
30
2
2
Clevis
Copper joiner
2
Screw (2x10mm)
2
Washer(2x5mm)
Steel wire
Copper joiner
Lock Nut (2mm )
Screw (2x10mm)
Clevis
Washer(2x5mm)
Install the servo of the rudder.
Assemble the servo of the rudder in the fuselage and
connect the servo and the rudder via steel wires.
Lock the linkage to the control horn with screws and nuts
as below.
The sketch map of how the steel wires works for the rudder.
Steel wire
Copper joiner
Aluminum tube
Clevis
Nut 2mm
Screw (2x10mm)
Washer(2x5mm)
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
The sketch map should be when the rudder and stabilizer
install completion.
A
A = A ’
B = B ’
A ’
B
B ’
Accessory list for the coming installation steps.
1
Engine mount (60x5mm)
Linkage Stopper
12
4
Washer(4x8mm)
Screw (4x45mm)
2
4
Screw (4x20mm)
4
4
Plastic tube (2x400mm)
Fuel tank (550cc)
1
1
Cable tie
2
Rod (2x400mm)
Blind Nut (5mm)
33
34
35
32
36
7
