Tail wheel
Washer(3x15mm)
Screw (3x65mm)
Lock Nut (3mm )
Clevis
Aluminum tube
Steel wire
2
Steel wire (0.5x1200mm)
1
3
2
2
Clevis
Retainer
Washer(3x15mm)
Lock Nut (3mm )
1
Screw (3x65mm)
2
Copper joiner
30mm
2.5mm
3mm
Retainer
TP Screw (2.3x8mm)
8
TP Screw (2.3x8mm)
Ply (15x15x3mm)
8
Rod (2X300mm)
1
Drill holes to the relevant position in the tailing edge
and epoxy the rudder to them.
Drill a hole to appropriate position in the
rudder as illustration.
The sketch map after the rudder shaft assemble finished.
The sketch map of the linkage for the rudder
and the tail wheel.
The sketch map of the linkages for the rudder
and elevator in the fuselage.
Epoxy ply to appropriate position in the fuselage
and assemble the tail gear cover with screw.
50
51
53
54
10
49
52
4
Blind Nut (4mm)
1
Engine mount (68x105mm)
Linkage Stopper
4
4
12
4
Washer(4x8mm)
Screw (4x35mm)
Spring Washer (4mm)
Nut (4mm)
2
4
Screw (4x25mm)
2
Plastic tube (2x400mm)
Fuel tank (550cc)
1
In case of 2-cycle & 4-cycle engine.
155 mm
Washer (4x8mm)
Washer (4x8mm)
Washer (4x8mm)
Screw (4x35mm)
Screw (4x25mm)
Nut (4mm)
Spring Washer (4mm)
4mm
4.2mm
Blind Nut
Blind Nut (4mm) 4
Set Screw (3x4mm)
Set Screw (2mm)
Rod (2x400mm)
Set Screw (2mm)
Washer (2mm)
Linkage Stopper
1
1
1
1
Washer (4x8mm)
4
Set Screw (3x4mm)
The front view of the engine installation finished.
The side sketch map of the engine installation finished.
Drill 4 holes and set blind nut in appropriate position
in the firewall before install the engine.
Install the engine carefully.
Assemble the accelerator push rod to the engine.
34
35
36
37
33
7
Accessory list for the coming installation steps.
