Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
2
1
Steel wire (0.5x3000mm)
U-style wire (3mm)
U-style wire (3mm)
2x20mm
1
Stab joiner (12x300mm)
3mm
Make sure hinges are
mounted in the same line.
6
Pin hinge(4.5x67mm)
30mm
60mm
76mm
1mm
Tailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Elevator
Steel wire (0.5x3000mm)
Apply instant type AB glue to elevator and pin hinge.
Keep some space about 1mm width between
elevator and tailing edge.
Set the U-style wire through the enlarged hole as below.
Epoxy the stabilizer to the fuselage,trim a small slot in
appropriate position in the stabilizer and glue the U-style
wire to it.
2
2
Clevis
Copper joiner
2
2
Screw (2x10mm)
Nut (2mm )
2
Washer(2x5mm)
Steel wire
Copper joiner
Lock Nut (2mm )
Screw (2x10mm)
Ball joint
Washer(2x5mm)
Aluminum tube
Install the servo.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
3mm
3mm
Epoxy the elevator to the stabilizer.
27
28
29
30
32
6
31
In case of 2-cycle & 4-cycle engine.
6.2mm
Blind Nut
193mm
Blind Nut (5mm) 4
Washer
Screw
Washer
1
Linkage Stopper
4
12
Washer
Spring Washer
1
4
Screw
Plastic tube (2x650mm)
Washer
4
4
Blind Nut (5mm)
Fuel tank (550cc)
1
2
o
Engine mount is a movable cylinder.
Elevator servo
Fix the elevator servo to appropriate position
in the fuselage.
The side view when the engine installation finished,the steps should be assemble
the engine to engine mount after step 36 &37,adjust the engine mount to a proper
position,epoxy the engine mount to the fuselage with AB glue.
Assemble the engine.
The engine will be 2 degree right skewed once the
engine install completion.
Drill 4 holes in appropriate position in the movable
cylinder and set blind nut in them.
34
35
36
37
7
Accessory list for the coming installation steps.
33
