![background image](http://html1.mh-extra.com/html/troy-bilt/v809h/v809h_operators-manual_1173076016.webp)
16
•
Keep the blades sharp and replace the blades
when worn. Refer to
Cutting Blades
on page 23 of this
manual for proper blade sharpening instructions.
Operating The Headlights
To turn the tractor’s headlights on:
•
Start the engine following the instructions earlier in
this section.
•
Turn the key one notch counterclockwise into the
On/Lights position of the ignition switch. Refer to
Figure 6.
To turn the tractor’s headlights off:
•
Turn the key either into the On position (to leave the
engine running) or the Off position (to shut the
engine off). Refer to Figure 6.
NOTE:
Never move the key into the Start position
while the engine is running. Doing so may cause
damage to your engine’s electric starter.
SECTION 6: MAKING ADJUSTMENTS
WARNING:
Never attempt to make any
adjustments while the engine is running,
except where specified in the operator’s
manual.
WARNING:
Disconnect the spark plug
wire(s) and ground against the engine before
performing any adjustments, repairs or
maintenance.
Parking Brake Adjustment
WARNING:
Never attempt to adjust the
brakes while the engine is running. Always
disengage PTO, move shift lever into neutral
position, stop engine and remove key to
prevent unintended starting.
If the tractor does not come to a complete stop when
the brake pedal is completely depressed, or if the
tractor’s rear wheels can roll with the parking brake
applied, the brake is in need of adjustment. The brake
disc can be found on the right side of the transmission
in the rear of the tractor. Adjust if necessary as follows:
•
Looking at the transmission from the right side of
the tractor, locate the compression spring and
brake disc.
•
Loosen, but do NOT remove, the hex nut found on
the right side of the brake assembly.
•
Using a feeler gauge, set the gap between the
brake disc and the brake puck at .011".
•
Re-tighten the hex nut loosened earlier.
Seat Adjustment
WARNING:
Before operating this machine,
make sure the seat is engaged in the seat
stop, stand behind the machine and pull back
on seat until fully engaged into stop.
To adjust the position of the seat, move the seat
adjustment lever to the left and slide the seat forward or
rearward. Make sure seat is locked into position before
operating the tractor.
Steering Adjustment
If the tractor turns tighter in one direction than the other,
or if the ball joints are being replaced due to damage or
wear, the steering drag links may need to be adjusted.
Adjust the drag links so that equal lengths are threaded
into the ball joint on the left side and the ball joint on the
right side:
•
Loosen the jam nut found on the drag link at the
rear of the ball joint. See Figure 10.
Figure 10
•
Remove the hex nut and lock washer on the top of
ball joint. See Figure 10.
•
Thread the ball joint toward the jam nut to shorten
the drag link. Thread the ball joint away from the
jam nut to lengthen the drag link.
Drag Link
Ball Joint
Axle
Pivot Bar
Hex Nut and
Jam Nut
Lock Washer