![background image](http://html1.mh-extra.com/html/troy-bilt/tb6044-xp/tb6044-xp_operators-manual_1173576011.webp)
11
USING THE ELECTRIC START ACCESSORY
STOPPING INSTRUCTIONS
1. Release the throttle control and allow the engine to idle.
2. Press and hold the On/Off switch in the OFF (O) position until
the engine comes to a complete stop (Fig. 8).
This unit can be started with an optional electric start accessory
(items sold separately). Refer to the electric start accessory
operator’s manual for the proper use of this feature.
Please contact your local retailer, call the Customer Support
Department or visit our website for more information.
Fig. 11
Electric Start
Port
Item No.
Description
49M2027P966 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Electric Starter
49MESCBP966 . . . . . . . . . . . . . . . . . . . . . . . . . . . .Engine Starter Bit
49MRBESY966 . . . . . . . . . . . . . . . . . . . . . .Cordless Electric Starter
STARTING INSTRUCTIONS
1. Check the oil level. Refer to
Checking the Oil Level
.
2. Fill the fuel tank. Refer to
Fueling the Unit
.
NOTE:
There is no need to turn the unit on. The On/Off switch is in
the ON ( I ) position at all times (Fig. 8).
3. Slowly press and release the primer bulb
10 times
(Fig. 9).
4. Crouch in the starting position (Fig. 10).
5. Insert the electric start accessory into the electric start port (Fig.
11). Refer to the
Operation
section of the electric start accessory
operator’s manual.
6. Press and hold the throttle lockout (Fig. 8). Squeeze and hold
the throttle control (Fig. 8).
7. Continue to hold the throttle lockout and throttle control. Run the
electric start accessory in intervals no longer than 2 seconds
each until the unit starts.
8. Remove the electric start accessory from the unit.
IF...
the engine does not start, begin the starting procedure with step 3.
IF...
the engine fails to start after 3 attempts: Press and hold the
throttle lockout. Squeeze and hold the throttle control. Run the
electric start accessory in intervals no longer than 2 seconds
each until the unit starts.
IF...
the engine stops while the throttle control is squeezed, begin
the starting procedure with step 3.
IF THE ENGINE IS HOT...
begin the starting procedure with step 3.