16
INSTALLING AND ADJUSTING THE HANDLE
(Handle Type A)
Installing the Handle
1. Push the handle down onto the upper shaft housing (Fig. 8). Make sure the hex bolt hole faces to
the left (Fig. 8).
2. Insert the bolt into the hex bolt hole and push it through (Fig. 9). Place the washer onto the bolt
(Fig. 9). Screw the wing nut onto the bolt, but do not tighten the wing nut completely (Fig. 9) .
3. Hold the unit in the operating position (Fig. 15). Move the handle up or down the upper shaft
housing to a comfortable location (Fig. 9). Make sure the handle is positioned beyond the end of
the safety label (Fig. 9).
4. Tighten the wing nut until the handle is secure.
Adjusting the Handle
If the handle requires adjustment:
1. Loosen the wing nut (Fig. 9).
2. Hold the unit in the operating position (Fig. 15). Move the handle up or down the upper shaft
housing to a comfortable location (Fig. 9). Make sure the handle is positioned beyond the end of
the safety label (Fig. 9).
3. Tighten the wing nut until the handle is secure.
HANDLE ASSEMBLY
Follow the instructions that apply to the handle included with your unit. Refer to
Installing and
Adjusting the Handle
.
Fig. 8
Handle
Upper Shaft
Housing
Hex Bolt Hole
Summary of Contents for TB25CB
