If the overload protection switch pops out shortly after resetting:
Release the motor/blade control handle and do NOT restart
1.
the mower for at least 15 minutes to allow the electric
motor extra time to cool.
Press the overload protection switch inward to reset.
2.
Restart unit.
3.
NOTE:
If the overload protection switch pops out
repeatedly during operation or will not remain in when
attempting to reset, you may need to raise the cutting
height to reduce the strain on the motor or recharge the
battery. If the overload protection switch will not remain in,
contact an authorized service center to arrange for repair.
Replacing Trail Shield
WARNING:
Never operate mower unless the trail
shield is in place and working. Never operate mower
with damaged safety devices. Failure to do so, can
result in personal injury.
The trail shield is subject to wear and damage which could
expose moving parts or allow objects to be thrown. For safety
protection, frequently check the trail shield and replace
immediately with original equipment manufacturer’s (OEM) part
only, listed in this manual.
Using a 10mm wrench, hold one lock nut in place while the
1.
opposite lock nut is loosened and removed. See Fig. 6-3.
Remove the rod running through the trail shield and
2.
replace with new shield in the opposite order and manner
of removal.
Figure 6-3
Battery Care
IMPORTANT:
Replace with only the identical batteries provided
with this mower. The batteries should only be replaced by an
authorized service dealer.
WARNING:
Due to a potential shock hazard, DO
NOT attempt to remove the motor/battery shroud.
There are no user serviceable parts inside. Contact
your nearest Authorized Service Center if repairs are
needed.
16
s
ectiOn
6— M
aintenance
& a
djustMents
Summary of Contents for TB E25
Page 20: ...20 Model TB E25 For a new battery pack order part 725 05089 20 ...
Page 22: ...Notes 10 22 ...
Page 23: ...23 Section 10 Notes ...
