Troy-Bilt Super Bronco 60TG, Operator'S Manual

Page: 14 / 48

14
4
Operating
Your Lawn
Tractor
2. Turn the key from the NORMAL MOWING (Green)
position to the REVERSE CAUTION MODE (Yellow)
position of the key switch module. See Figure 9.
3. Depress the REVERSE PUSH BUTTON (Orange,
Triangular Button) at the top, right corner of the key
switch module. The red indicator light at the top, left
corner of the key switch module will be
ON
while
activated. See Figure 9.
4. Once activated (indicator light
ON
), the tractor can
be driven in reverse with the cutting blades (PTO)
engaged.
5. Always look down and behind before and while
backing to make sure no children are around.
6. After resuming forward motion, return the key to the
NORMAL MOWING
position.
IMPORTANT : The REVERSE CAUTION MODE will
remain activated until:
a. The key is placed in either the NORMAL MOW-
ING position or STOP position.
b. The operator engages the parking brake by fully
depressing the brake pedal and holding it down
while gently pushing the parking brake button
inward.
Engaging the Parking Brake
To engage the parking brake:
1. Fully depress the brake pedal and hold it down with
your foot while gently pushing the parking brake
button inward.
2. Hold the parking brake button in while removing your
foot from the brake pedal.
�����
��������
����
��������
�������
�����������
�������
������������
��������
���������
�����
Figure 9
WARNING
AVOID SERIOUS INJURY OR DEATH
• GO UP AND DOWN SLOPES, NOT ACROSS.
• AVOID SUDDEN TURNS.
• DO NOT OPERATE THE UNIT WHERE IT COULD SLIP OR TIP.
• IF MACHINE STOPS GOING UPHILL, STOP BLADE(S) AND
BACK DOWNHILL SLOWLY.
• DO NOT MOW WHEN CHILDREN OR OTHERS ARE AROUND.
• NEVER CARRY CHILDREN, EVEN WITH BLADES OFF.
• LOOK DOWN AND BEHIND BEFORE AND WHILE BACKING.
• KEEP SAFETY DEVICES (GUARDS, SHIELDS, AND SWITCHES)
IN PLACE AND WORKING.
• REMOVE OBJECTS THAT COULD BE THROWN BY THE
BLADE(S).
• KNOW LOCATION AND FUNCTION OF ALL CONTROLS.
• BE SURE BLADE(S) AND ENGINE ARE STOPPED BEFORE
PLACING HANDS OR FEET NEAR BLADE(S).
• BEFORE LEAVING OPERATOR’S POSITION, DISENGAGE
BLADE(S), PLACE THE SHIFT LEVER IN NEUTRAL, ENGAGE
BRAKE LOCK, SHUT ENGINE OFF AND REMOVE KEY.
READ OPERATOR’S MANUAL
3. Once engaged, the parking brake button and the brake
pedal will lock in the “down” position.
To disengage the parking brake:
1. Slightly depress the brake pedal.
NOTE
: The parking brake must be engaged if the operator
leaves the seat with the engine running or the engine will
automatically shut off.
Setting the Cutting Height
1. Select the height position of the cutting deck by placing
the deck lift lever in any of the six different cutting
height notches on the right side of the fender.
2. Adjust the deck wheels so that they are between
¼-inch and ½-inch above the ground when the tractor
is on a smooth, flat surface such as a driveway.
WARNING: Keep hands and feet
away from the discharge opening
of the cutting deck.
WARNING
Keep hands and feet
away from the dis-
charge opening of the
cutting deck.