![background image](http://html.mh-extra.com/html/troy-bilt/storm-tracker-31ah7t74063/storm-tracker-31ah7t74063_operators-manual_1173302005.webp)
5
SECTION 2: ASSEMBLING YOUR SNOW THROWER
Unpacking
•
Remove screws from the top sides and ends of the
shipping crate.
•
Set panel aside to avoid tire punctures or personal
injury.
•
Remove and discard plastic bag that covers unit.
•
Remove any loose parts included with unit (i.e.,
Operator’s Manual, etc.).
•
Roll unit out of crate.
Loose Parts
The augers are secured to the auger shaft with two
shear bolts and hex lock nuts. If you hit a foreign object
or ice jam, the snow thrower is designed so that the
bolts may shear. Two replacement shear bolts and nuts
are provided for your convenience. Store in a safe
place until needed. See Figure 1.
Figure 1
IMPORTANT:
NEVER replace the auger shear bolts
with standard hex bolts. Any damage to the auger
gearbox or other components from using standard bolts
will not be covered by your snow thrower’s warranty.
Items Required For Assembly
1.
Pair of pliers
2.
Engine oil
3.
Fresh gasoline
Before Assembly
•
Disconnect spark plug wire and ground it against
the engine to prevent unintended starting.
NOTE: All references in this manual to the left or right
side of the snow thrower is from the operating position
only. Exceptions, if any, will be specified.
Assembling Handle
For shipping purposes, the upper handle is secured
loosely to the lower handle with four wing nuts.
•
Remove the lower plastic wing nut, cupped washer
and carriage bolt from each side of the lower
handle. See Figure 2.
•
Raise the upper handle assembly until it locks over
the lower handle.
•
Look at the lower rear of the snow thrower frame to
be sure all the cables are aligned with the cable
roller guides. Make sure the spring (found at the
end of each cable) is attached to its actuator
bracket.
•
Secure the upper handle and lower handle with the
two plastic wing nuts, cupped washers and carriage
bolts previously removed. Attach these hardware
on the lower hole in the handles. See Figure 2.
•
Tighten the two wing nuts already in place on the
upper holes and secure the handles firmly. Slide
the shift rod connector down over the end of the
lower shift rod. Tap the connector until it locks over
the lower shift rod. See Figure 2.
NOTE: If the connector is not properly assembled, the
shift rod will pivot and you will not be able to change
speeds or direction of movement.
Figure 2
Attaching Chute Crank
•
Remove the hairpin clip from the upper chute crank
and slide the upper chute crank through the upper
chute crank bracket and into the lower chute crank.
A pair of pliers may help in this job.
•
Align the two holes on both chute cranks and insert
the hairpin clip removed earlier, through these
holes. See Figure 2.
•
If not already attached, slip the cables that run from
the handle panel to the discharge chute into the
cable guide located on top of the engine. See
Figure 3.
Shear Bolts
Hex Lock
Nuts
Wing
Nut
Upper
Chute
Crank
Lower Chute Crank
Carriage Bolt
Hairpin Clip
Cupped
Washer
Carriage
Bolt