Assembly & Set-Up
3
7
Assembly
Handle
1.
Place the shift lever in the Forward-6 position.
2.
Observe the lower rear area of the snow thrower to be sure
both cables are aligned with roller guides before pivoting
the handle upward. See Figure 3-1.
Figure 3-1
NOTE:
Make certain the cables are seated properly in the
roller guides. See Figure 3-2.
Figure 3-2
3.
Secure the handle by tightening the plastic knob located
on both the left and right sides of the handle. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.
Contents of Carton
•
One Snow Thrower
•
Replacement Auger Shear Pins
•
One Chute Control Rod
•
One Chute Assembly
•
One Product Registration Card
•
One Snow Thrower Operator’s
Manual
•
One Engine Operator’s Manual
Summary of Contents for Storm Tracker 2690 XP
Page 46: ...Notas 9 46 ...
Page 47: ...47 Section 9 Notas ...
