![background image](http://html.mh-extra.com/html/troy-bilt/storm-series/storm-series_operators-manual_1173296017.webp)
1
Friction Wheel Removal
If the snow thrower fails to drive with the drive control
engaged, and performing the drive control cable adjust-
ment fails to correct the problem, the friction wheel may
need to be replaced. Follow the instructions below.
Examine the friction wheel for signs of wear or cracking
and replace if necessary
• Place the shift lever in third Forward (F3) position.
• Drain the gasoline from the snow thrower, or place a
piece of plastic under the gas cap.
• Carefully pivot the snow thrower up and forward so
that it rests on the auger housing.
1. a. Remove the frame cover from the underside of
the snow thrower by removing four self-tapping
screws which secure it, Figure 6-13.
b. Remove the right-hand wheel by removing the
screw and bell washer which secure it to the axle.
2. Carefully remove the hex nut and washer which
secures the hex shaft to the snow thrower frame and
lightly tap the shaft’s end to dislodge the ball bearing
from the right side of the frame, Figure 6-14.
3. Carefully position the hex shaft downward and to
the left before carefully sliding the friction wheel
assembly off the shaft, Figure 6-15.
NOTE: If you’re replacing the friction wheel assembly
as a whole, discard the worn part and slide the new part
onto the hex shaft. Follow the steps above in reverse
order to reassemble components. If you’re disassem-
bling the friction wheel and replacing only the rubber
ring, proceed as follows:
4. Remove the four screws which secure the friction
wheel’s side plates together, Figure 6-16.
• Remove the rubber ring from between the plates.
• Reassemble the side plates with a new rubber ring.
• Slide the friction wheel assembly back onto the hex
shaft and follow the steps above in reverse order to
reassemble components.
When reassembling the
friction wheel assembly,
tighten each screw only
one rotation before turning
the wheel clockwise and
proceeding with the next
screw. Repeat this process
several times to ensure
the plates are secured with
equal force.
NEVER replace the auger
shear pins with anything
other than OEM Part No.
738-04124A replacement
shear pins. Any damage to
the auger gearbox or other
components as a result of
failing to do so will NOT
be covered by your snow
thrower’s warranty.
6
Maintaining
Your Snow
Thrower
Figure 6-13
Figure 6-14
Figure 6-15
Figure 6-16