![background image](http://html1.mh-extra.com/html/troy-bilt/rzt-series-tractor-colt-zt42/rzt-series-tractor-colt-zt42_operators-manual_1173028029.webp)
29
s
ectiOn
7 — s
ervice
Working from the middle of the tractor, pivot the idler
2.
bracket and movable idler pulley rearward away from the
backside of the ‘V” belt just far enough to lift the belt up
and over the idler pulley. See Fig. 7-3.
From beneath the rear of the tractor, slide the belt off of
3.
the PTO pulley on the bottom of the engine.
Rolling the Belt off the PTO Pulley
Using the deck lift handle, raise the deck to the position
1.
that provides the most horizontal run of the belt between
the deck idler pulleys and the PTO pulley on the bottom of
the engine.
Sitting behind the tractor facing forward, reach beneath
2.
the tractor to grasp the belt at the front of the PTO pulley.
WARNING!
Use caution to avoid pinching your
fingers when rolling the belt off the PTO pulley.
Pull the left side of the belt rearward and downward while
3.
manually turning the PTO pulley to the right until the belt
rides out onto the edge of the lower sheave of the pulley.
NOTE:
If pulling the right side of the belt, turn the pulley to
the left.
Rear Deck
Hanger Bracket
Deck Lift Arm
Deck
Support
Pin
Rear Hanger
Bracket Slot
Figure 7-5
Pull Idler Pulley
Rearward
Movable Idler
Pulley
Idler Bracket
Fixed Idler
Pulley
V-Belt
While still holding the belt downward, continue turning the
4.
PTO pulley until the belt is rolled off the pulley. Refer to Fig. 7-4.
Lower the deck to the ground using the deck lift handle.
5.
Locate the LH and RH deck support pins on each side of the
6.
deck. Pull the deck support pins outward and lock in the
disengaged position to release the deck from the tractor’s
LH and RH deck lift arms. Refer to Fig. 7-5.
Raise the deck lift arms out of the rear hanger bracket slots
7.
by raising the deck lift handle on the tractor to its highest
position. Refer to Fig. 7-5.
Slide the deck forward so that the deck front hanger rod can
8.
be lifted out of the two slots of the front deck bracket. After
lifting the front hanger rod out of the slots, slide the deck
rearward so that the rod can no longer engage the slots.
Using care to prevent the front hanger rod from falling
9.
back into the deck bracket slots, carefully slide the cutting
deck (from the right side) out from underneath the tractor.
Figure 7-3
PTO Pulley
PTO Belt
Transmission
Tube
Figure 7-4
Summary of Contents for RZT Series Tractor - Colt ZT42
Page 37: ...Notes 11 37...