![background image](http://html1.mh-extra.com/html/troy-bilt/pro-line/pro-line_operators-manual_1173433009.webp)
Wheel Gear Lever
Insert the Wheel Gear Lever up through the slot in the
control panel that is labeled “WHEEL GEAR.” See Fig. 3-8.
Insert two #10-32 x 1⁄2” round head screws down through
the “+” marks on the control panel decal and securely
attach the wheel gear mounting bracket using two #10
lockwashers and #10-32 nuts.
Use a small board to tap the Wheel Gear Lever knob
securely onto the lever.
Secure the wheel gear cable and the reverse clutch control
cable to the leftside handlebar with two plastic ties located
about two feet apart. Snip off any excess with scissors. See
Fig. 3-9.
1.
2.
3.
4.
Set-Up
Tires
Use a tire pressure gauge to check the air pressure in both tires.
Deflate or inflate both tires equally to between 15 PSI and 20 PSI.
Be sure that both tires are inflated equally or the tiller will pull to
one side.
Gas & Oil Fill-Up
Service the engine with gasoline and oil as instructed in the
Engine Operator’s Manual packed seperately with your tiller.
Read the instructions carefully.
WARNING!
Use extreme care when handling
gasoline. Gasoline is extrememly flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and any other
sources of ignition.
Transmission Gear Oil
The transmission was filled with gear oil at the factory. However,
be sure to check the oil level at this time to make certain it
is correct. See the Maintenance & Adjustments Section for
instructions on checking and adding transmission gear oil.
Wheel Gear
Lever
Cable
Ties
Figure 3-
Figure 3-9
9
s
ectiOn
2 — a
sseMbly
& s
et
-u
p