IMPORTANT: Your new row marker is designed to attach to the Troy-Bilt Hiller-Furrower attachment. If you don’t have Hiller-
Furrower, call us or visit www.troybilt.com to place an order:
OEM-290-250
for Horse Model tillers
OEM-290-251
for Pony, Econo-Horse and Junior Model tillers
Introduction
Row Marker OEM-290-257
will help you lay out your garden with speed, accuracy and convenience — without the bother of
stakes, strings, tape measures and other tools. It’s fast and easy to assemble, mount and use with your TROY-BILT HORSE Model,
ECONO-HORSE, PONY or JUNIOR Model tiller too! Just follow these assembly & use instructions.
NOTE:
If you ordered a Hiller-Furrower with your Row Marker, be sure to install the Furrower blade first, as the Row Marker
attaches directly to the Furrower blade and must be used with it. Separate assembly instructions are included with the Hiller-
Furrower. If you already had a Hiller-Furrower, just attach the Furrower blade to your TROY-BILT Tiller as always and follow the
Row Marker instructions here.
Row Marker
OEM-290-257 / 290-257-081
1
1904522
Main Support & Yoke Assembly ....... 1
2
GW-1594
Marker Blade ..................................... 1
3
1904524
Main Marker Arm .............................. 1
4
1904523
Marker Arm Extension (w/ stop pin). 1
5
GW-1837
Hardware Package (includes below) . 1
GW-9347
Hitch Pin ........................................... 1
GW-9828
Hex Nut, #10-24................................ 2
1100135
Screws, #10-24 x 1 ........................... 2
GW-9786
Thumb Screws, 1/4-20...................... 2
GW-1596
Nut Bar .............................................. 1
REF.
PART
No.
No.
DESCRIPTION
QTY.
TO PREVENT INJURY FROM MOVING PARTS OR HOT
SURFACES:
• Stop the engine and wait for all moving parts to
stop.
• Disconnect the spark plug wire from the spark plug
and allow the muffler to cool.
Tools Needed
• 9/16” wrench (or adjustable wrench)
• 3/8” wrench (or adjustable wrench)
• Pliers
Step 1: Attach Main Support to the Furrower
1. Using a 9/16” wrench or adjustable wrench, first
remove the two 3/8” hex nuts and lockwashers that
secure the furrower blade to its bracket.
2. Position the Row Marker Main Support on the two
3/8”-16 x 1-1 /2” long bolts (A and B in Photo 1).
Note:
The Stop Bar on the Main Support faces out toward
the operator and the two bottom holes in the Main Support
are used for mounting.
3. Replace both lockwashers and hex nuts and tighten
securely.
4. Using a 9/16” wrench, remove hex nuts and lockwash-
ers from bolts “A” and “B“, install Main Support on
bolts as shown. Replace nuts and washers.
WARNING
Be sure you received all the hardware and parts listed below. If anything is missing or damaged, please write or give us a call
using the information provided on the back cover of this manual.
Contents of Carton
Summary of Contents for OEM-290-257
Page 6: ...NOTES...
Page 7: ...NOTES...
