![background image](http://html.mh-extra.com/html/troy-bilt/772c0767/772c0767_operators-manual_1173266007.webp)
7
The drive control also locks the auger control so you
can turn the chute directional control without
interrupting the snow throwing process. If the auger
control is engaged simultaneously with the drive
control, the operator can release the auger control (on
the left handle) and the augers will remain engaged.
Release both controls to stop the augers and track
drive.
IMPORTANT:
Always release drive control before
changing speeds.
Auger Drive Control
The auger drive control is located on
the left handle. Squeeze the control
grip to engage the augers. Release to
stop the snow throwing action. The
drive control must also be released in
order to stop auger. See Figure 6.
IMPORTANT:
Refer to
Auger Control Test
on page 10 prior
to operating your snow thrower. Read and follow all
instructions carefully and perform all adjustments to
verify your snow thrower is operating safely and
properly.
Shift Lever
The shift lever is located in the cen-
ter of the handle panel and is used to
determine both ground speed and
direction of travel. It can be moved
into any of eight positions. See Fig-
ure 6.
IMPORTANT:
Always release drive
control before changing speeds.
Forward
Your snow thrower has six forward
(F) speeds, with position number
one (1) being the slowest speed,
and position number six (6) being
the fastest.
Reverse
Your snow thrower has two reverse (R) speeds, R1 is
the slower of the two.
Chute Tilt Control
The distance snow is thrown can be
changed by adjusting the angle of the
chute assembly. Move the chute tilt
control forward to decrease the
distance, toward the rear to increase.
Chute Crank
The chute crank is located on the left
side of the snow thrower. Use it to
change the direction in which snow is
thrown. Avoid targeting persons,
animals or cars and buildings.
Skid Shoe
The space between the shave plate and the ground can
be adjusted by positioning the skid shoes. Refer to
Skid
Shoe Adjustment
on page 12.
Clean-Out Tool
The clean-out tool is designed to clear a clogged chute.
Refer to page 10 for instructions on how to properly use
it.
WARNING:
Never use your hand to clear
a clogged chute. Shut off engine and remain
behind handles until all moving parts have
stopped before unclogging.
Heated Handles Switch
(on some models)
This switch is located on the right side of the snow
thrower dash panel. To activate the heated handles,
toggle the switch to the right to generate heat within the
handle grips. Toggle the switch to the left to the OFF
position after using the snow thrower. See Figure 6.
NOTE:
The heated handles grips are a compliment to,
not a substitute for, proper cold weather outerwear for
the operator’s hands. It is recommended that the snow
thrower operator wear gloves/mittens to avoid
extremities of winter while operating this equipment.
Track Steering Controls
The left and right track steering
controls are located on the underside
of the handles and they are used to
assist in steering the snow thrower. Squeeze the right
track control when turning right, squeeze the left control
when turning left. Operate your snow thrower in open
areas until you become familiar with these controls.
See Figure 6.
NOTE:
It is easier to maneuver a non-running snow
thrower with both track steering controls held in
simultaneously.
Throttle Control
The throttle control is located on the engine. It regulates
the speed of the engine and will shut off the engine
when pushed down completely. See Figure 6.
6
1
2
F
3
4
5
R2
R1
R
C L O C K W I S E T O
DISCHARGE LEFT
COUNTER CLOCKWISE
TO DISCHARGE RIGHT
Summary of Contents for 772C0767
Page 23: ...23 notes ...