![background image](http://html.mh-extra.com/html/troy-bilt/769-03618/769-03618_operators-manual_1173402017.webp)
Transmission Gear Oil
Check the transmission gear oil after every 30 hours of operation
or whenever you notice any oil leak. Operating the tiller when
the transmission is low on oil can result in severe damage.
To Check the Transmission Gear Oil Level:
Check the gear oil level when the transmission is cool. Gear
oil will expand in warm operating temperatures and this
expansion will provide an incorrect oil level reading.
With the tiller on level ground, pull the Depth Regulator
Lever all the way up.
Remove the oil fill plug from the transmission housing and
look inside the oil fill hole to locate the main drive shaft
situated below the hole. Refer to Fig. 6-1.
The gear oil level is correct if the gear oil is approximately
halfway up the side of the main drive shaft.
If the gear oil level is low, add gear oil as described below. If
the gear oil level is okay, securely replace the oil fill plug.
If adding only a few ounces of gear oil, use API rated GL-4
or GL-5 gear oil having a viscosity of SAE 140, SAE 85W-140
or SAE 80W-90. If refilling an empty transmission, use only
GL-4 gear oil having a viscosity of SAE 85W-140 or SAE 140.
While checking frequently to avoid overfilling, slowly add
gear oil into the oil fill hole until it reaches the halfway
point on the drive shaft.
Securely replace the oil fill plug.
1.
2.
3.
4.
5.
6.
7.
8.
Lubrication
After every 10 operating hours, oil or grease the lubrication
points shown in Fig. 6-2 and described below.
Use a clean lubricating oil (#30 weight motor oil is suitable)
and a clean general purpose grease (grease containing a metal
lubricant is preferred, if available).
Remove the wheels, clean the wheel shaft and apply a thin
coating of grease to the wheel shaft.
Grease the back, front and sides of the depth regulator
lever.
Remove the tines and clean the tine shaft. Use a file or
sandpaper to gently remove any rust, burrs or rough spots
(especially around holes in shaft). Apply grease to the
ends of shaft before installing the tines.
Oil the threads on the handlebar height adjustment screws
and the handlebar attaching screws.
•
•
•
•
Wheel Shaft
Tine Shaft
Handlebar
Attaching Screws
Depth
Regulator
Lever
Figure 6-
Oil Fill Plug
Figure 6-1
1
s
ectiOn
6 — M
aintenance
& a
djustMents
Summary of Contents for 769-03618
Page 23: ...Notes 10 23 ...
Page 47: ...Notas 9 23 ...