![background image](http://html.mh-extra.com/html/troy-bilt/500-series/500-series_operators-manual_1173249005.webp)
5
SECTION 2: SETTING UP YOUR SNOW THROWER
NOTE:
The snow thrower is shipped with oil and
WITHOUT GASOLINE. After assembly, refer to
separate engine manual for proper fuel and engine oil
recommendations.
NOTE:
This Operator’s Manual covers several models,
handle panels, lights and chute cranks are some
features that may vary by model. Not all features
referenced in this manual are applicable to all
snowthrower models.
Unpacking
•
Cut along corners of the carton and lay it down flat.
Remove packing material.
•
Remove any loose parts included with unit (i.e.,
operator’s manual, etc.).
•
Roll unit out of carton. Check carton thoroughly for
any remaining loose part.
Loose Parts
Your snow thrower has been assembled at the factory
except the parts shipped loose in the carton. These are
listed below.
a. Electric Start Cord (optional)
b. Shear Pins and Cotter Pins
Before Assembly
Disconnect spark plug wire and ground it against the
engine to prevent unintended starting.
NOTE:
All references in this manual to the left or right
side of the snow thrower is from the operating position
only. Exceptions, if any, will be specified.
Setting up the Snow Thrower
1.
Raise the upper handle assembly in the direction
shown in Figure 1. Align the upper handles with the
lower handle.
2.
Tighten two handle knobs firmly to secure the
upper handle to the lower handles. See Figure 1.
3.
Slide the shift rod connector down over the end of
the lower shift rod. Tap the connector until it locks
over the lower shift rod. See Figure 2.
NOTE:
If the connector is not properly assembled, the
shift rod will pivot and changing speed or direction of
the snow thrower will not be possible.
Chute Assembly (all models)
1.
Apply a light lubricant (i.e. 3-in-1 oil) to the base of
the chute assembly.
2.
Place the chute assembly on the lip of the chute
adapter. See Figure 3.
Figure 1
Figure 2
.
Figure 3
Handle Knob
Ra
is
e
ha
ndl
e
thi
s
w
ay
Shift Rod
Connector
Chute
Assembly
1
2
Summary of Contents for 500 series
Page 23: ...23 NOTES ...
Page 27: ...27 NOTES ...