Servicing the Troy-Bilt Wide Cut 33” Combination Mower
2
The fuse is located on the right side next to the battery
and the solenoid is mounted on the battery support
bracket under the battery. See Figure 4.
Most electrical problems can be diagnosed using a
ohm meter and checking continuity of the ignition
switch and wires to each component. See Figure 5.
NOTE:
The Operator’s Manual that comes with
the unit has a wealth of information regarding
the setup, operation and servicing of this unit.
NOTE:
This Service Manual is a supplement to
the Operator’s Manual.
IMPORTANT:
Please read, understand and fol-
low all safety procedures listed in the Operator’s
Manual when working on this unit.
CAUTION:
Before servicing the unit place it on a
level surface, turn off the engine and let the unit
cool, and disconnect the spark plug wire. On
electric start units, make sure the key is in the
“off” position.
1.
BLADE DRIVE BELT REMOVAL
1.1.
Make sure the blade drive control is disen-
gaged.
1.2.
Using a ½ inch socket remove the four screws
securing the belt cover and removed the cover.
See Figure 6.
1.3.
Using a ½ inch socket, remove the two screws
attaching the flap bracket to the frame. Remove
the flap bracket. See Figure 7.
Figure 4
Fuse
Starter Motor
Solenoid
Figure 5
Figure 6
Cover Screws (2 on each side)
Figure 7
Flap Bracket
Mounting Screws
View From Below
Summary of Contents for 12A-E753B063
Page 2: ......
Page 22: ...Servicing the Troy Bilt Wide Cut 33 Combination Mower 20...
