Troxler Enhanced RoadReader Plus 3451, Manual Of Operation And Instruction

Page: 54 / 247

Model 3451 3–19
PROJECT FILES
The Model 3451 stores measurement results in files called projects ,
which are named by the operator. The Project function allows the
operator to create a new project, view project data, erase projects,
enable a project (make an existing project active so that additional
data may be added to it), or disable the active project.
NOTE
The gauge will not take a reading unless a project has
been created and is active.
To access the Project function, press
〈
Project Access
〉
on the
main menu (see Figure 3–11). The PDA displays the
Project
Menu
shown in Figure 3–12.
When checked, the
Disable Storage to Gauge
check box
prevents the PDA from storage measurement data to the gauge for
storage following a reading. The
Disable Project Notes
check
box disables the
Would you like to add project notes?
prompt
that otherwise is displayed following a measurement.
The following sections describe the other functions available from
the
Project Menu
.
NOTE
The Project function cannot be used to enter target
values, offsets, or special calibrations. For information
on entering target values, see page 5–14. For
information on using offsets and special calibrations,
refer to
Chapter 6 .
NEW PROJECT
To create a new project, press the
〈
New
〉
button on the
Project
Menu
shown in Figure 3–12. The PDA displays the first page of the
setup
Wizard
for a new project, as shown in Figure 3–13.
3
. G
E
T
T
IN
G
ST
A
R
T
ED