EN
9
infrared heating panel TIH 350+ / TIH 650+
Positioning
A number of spatial and technical conditions have to be
considered for the selection of the device's installation site.
Non-observance may impair the proper functioning of the device
or the accessories or can entail risks of personal injury and
property damage.
•
Set the device up in an upright and stable position.
•
Make sure that there are no curtains or similar objects in
the immediate vicinity.
•
Set the radiator up in a way that the radiating side (5), i.e.
the dark side, points towards the surface to be dried. If the
feet touch the wall, the distance between panel and wall is
optimal.
Do not install the device directly in front of a wall socket.
The socket should be located next to the device.
•
When using more than 3 infrared panels, please use
separate circuits.
•
The devices can be installed both upright and horizontally.
•
Always set the infrared heating panel up in a way that the
dark, radiating side (5) faces a wall. The distance to the
wall may amount to maximally 20 cm.
•
Observe any regulations applicable for the installation site
during the set-up of the infrared heating panel.
Start-up
When positioning the device, observe the minimum distance
from walls or other objects as described in the Technical data
chapter.
A
B
C
C
D
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Set the device up in an upright and stable position.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
Make sure that there are no curtains or similar objects in
the immediate vicinity.
Connecting the power cable
•
Insert the mains plug into a properly secured mains
socket.
