EN
8
Operating manual – gas heater fan TGH 10 E / TGH 15 E / TGH 30 E
4. Connect the other end of the gas hose to the hose
connection of the device. For this purpose, screw the union
nut of the gas hose onto the gas connection of the device
by turning it counter-clockwise. Use an open-end wrench
of size SW 17 or SW 19 to do so.
Start-up
Info
Odours might arise upon initial start-up or after a
longer period of non-use. There might be a passing
smell of burnt material.
A smell of gas however indicates a leak at the gas
connection that must be remedied immediately.
Otherwise there is an explosion hazard!
A number of spatial and technical conditions have to be
considered for the selection of the device's installation site.
Non-observance may impair the proper functioning of the device
or the accessories or can entail risks of personal injury and
property damage.
Only use the device in rooms corresponding to the minimum
dimensions specified in the Technical data chapter. When
positioning the device, observe the minimum distance from
walls or other objects as described in the Technical data
chapter.
2 m
3,5 m
2 m
2 m
2,5 m
•
For outdoor application, the device may only be used when
located under a roof.
•
The device is to be set up in a stable position on
incombustible ground.
•
The room where the device is positioned must be
sufficiently ventilated. The ventilation shaft must have a
cross-section of at least 25 cm
2
per kW nominal heat
output. It is determined based on the calorific value.
•
Do not use the device in windowless basements or other
spaces below ground level.
•
The inlet and outlet openings must not be covered.
•
Never direct the air outlet towards the gas cylinder.
•
There must be no walls or large objects near the device.
•
There must be a sufficient number of fire extinguishers
available.
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
Make sure that the device cannot come into contact with
moisture or water.
Summary of Contents for TGH 10 E
Page 16: ......
