EN
6
Operating manual – designer glass convector TCH 2010 E / TCH 2011 E
3. Insert appropriate wall plugs into the bore holes depending
on the type of wall. In doing so, please make sure that the
screws protrude approx. 1 cm from the wall plugs so that
the device can be attached properly.
4. Suspend the device from the wall by use of the large cut-
outs of the holder.
5. Move the device slightly to the left and then down.
MODE
TIME
TEMP
TCH20
10 E
6. Make sure that the device is attached securely.
Start-up
Info
Odours might arise upon initial start-up or after a
longer period of non-use.
When positioning the device, observe the minimum distance
from walls or other objects as described in the Technical data
chapter.
A
B
C
C
D
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Set the device up in an upright and stable position or
suspend the device horizontally.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
Make sure that no curtains or other objects interfere with
the air flow.
•
Do not position the device directly below a wall socket.
•
Make sure that the device cannot come into contact with
moisture or water.
Prior to initial start-up, insert the batteries in the remote control.
Connecting the power cable
•
Insert the mains plug into a properly secured mains
socket.
•
Make sure that the power cable is guided along the back
of the device. Never guide the power cable along the front
of the device!
Summary of Contents for TCH 2010 E
Page 14: ......
