Trotec Speedy 400, Operating Manual

Page: 85 / 89

Technical Datasheet
/ ‹ 2 ›
Laser Pointer 655nm, <0,99mWcw
Autofocus Sonar Technology
TM
Work area light LED
Additional standard features
Ergonomic access to working area, OptiMotion TM , coaxial air assist incl.
integrated pump, harsh environment protection kit, machine integrated
and partial coverable extraction slits, two Z-home positions, air-assist
nozzles (Ø3mm and Ø7 mm), housing with lockable casters
Options
Temperature sensor
Should the temperature inside the engraving compartment exceed a
critical value, the laser will signal this to the operator by a warning sound.
The operator then can take action immediately.
Gas-Kit light
For control of compressed air (free of mechanical dust, water and oil) max.
flow rate 150 l/min (40 gpm) with max. 10 bar (145 psi);
Water cooling For CO2 laser sources with 60 W, 80 W or 120 W, external cooler needed
Screw feet Additional to the rolls, for a good standing on the ground
Trotec Vision Print&Cut
1.1.1.1.1.1.1 Registration marks detection and compensation system
Max. working area without camera: 1016 x 610 mm (40

24 inch)
Max. working area with camera: 1004 x 610 mm (39.5  24 inch)
Industrial interface Stop / Stop interface to control the operation from extern
Accessories
Ferromagnetic engraving table
Allows to mount thin materials such as paper, films or foils with magnets to
ensure an even and flat surface to achieve optimal results
Vacuum table Vacuum effect for fixation of thin or wavy materials
Acrylic cutting grid table (white) For reflection free cutting of tasks with parts smaller than 100 mm (4 inch)
Slat cutting table
For reflection-free cutting of thicker materials and parts bigger than 100
mm (4 inch); removable aluminium and acrylic slats, x-axis ruler can be
removed and mounted again without re-adjustment
Honeycomb cutting table
Good compromise between the Grid and Slat table configuration. The thin
support structures reduce flashback compared to a grid table and
combined with the high density of the honeycomb structure still provides
good support for less rigid material such as thin plastic, card & paper or
membrane boards; available with 0.5 inch (12,7 mm) or 0.25 inch (6,4 mm)
nominal comb size
Rotary attachment
Cone, roll or combined version, tilt able
Max. workpiece length cones: 730 mm (33.8 inch)
Max. workpiece
length rolls: Ø ≥ 58 mm (2.2 inch) = 889 mm (35 inch),
Ø ≤ 58 mm (2.2 inch) = 958 mm (37.7 inch)
Max. workpiece diameter cones: 270 mm (10.6 inch), depending on lens
Max. workpiece diameter rolls: 180 mm (7 inch), depending on lens
TroCare Comprehensive package of technical services