12
EN
digital soldering station PSIS 10-230V
Standby mode
The soldering station switches to standby mode if the soldering
iron (
9
) has not been used for 30 minutes.
In standby mode, a temperature of 200 °C is indicated on the
display and the indications on the display are flashing.
1. Press any button to exit the standby mode.
2. Prior to starting soldering works, adjust the desired
temperature as described in the Chapter Setting the
temperature.
Switching the device off
Note
Always put the soldering iron back into the soldering
iron holder after use.
1. Switch the on/off switch (
1
) to position "0".
1
ð
The display goes out. The soldering iron slowly cools
down.
Remove the mains plug from the mains socket if you do not use
the soldering station.
Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than those
specified in the operating manual may cause a risk of
injury.
Accessories
Article number
Set of soldering tips
6.236.001.001
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
Light smoke or odour is emitted during the first use:
•
This is not a fault. These phenomena disappear after a
brief runtime.
The device does not start:
•
Check the power connection.
•
Check the power cable and mains plug for damage. If you
notice damages, do not try to take the device back into
operation.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
•
Check the on-site fusing.
Info
Wait for at least 10 minutes before switching the
device back on.
The device is switched on but the solder is not liquid
enough or causes cold solder joints
•
The temperature of the soldering iron is too low. Check the
preset temperature. If necessary, increase the temperature
and wait until it has been reached.
•
The device is now in standby mode. Press any button to
exit standby mode, then set the desired temperature.
•
The temperature of the soldering iron is too high and burns
either the soldering agent, cable insulations or conducting
paths. Check the preset temperature. If necessary,
decrease the temperature and wait until it has been
reached.
•
The soldering tip is soiled. Clean the soldering tip by
wiping it on the moistened soldering sponge.
•
The soldering tip is worn out. Insert a new soldering tip to
ensure the soldering station's full power.
